buddy club head gasket ?
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2009
Location: wilkes-barre , pa
Posts: 3,384
Likes: 0
Received 0 Likes
on
0 Posts
buddy club head gasket ?
just would like to know are they any good pros and cons looking to get the 2 layer for a lil bump in compression
#2
Re: buddy club head gasket ?
Going with a thin head gasket would bump compression up a slight bit. However, it would not be a to much of a gain from a factory 3 layer to a 2 layer. If you would like a more noticeable gain a 1 layer gasket would be best if clearances permit. Of course the proper way to increase compression without the obvious of replacing pistons would be modifying/welding the combustion chamber.
#3
Re: buddy club head gasket ?
Depends also on what kind of setup/compression ratio you are running/after. Of course the meat of the motor would be where to start, but for just a little bump, go with the single layer unless you want to make more permanent changes..
Thread
Thread Starter
Forum
Replies
Last Post
98vtec
All Motor / Naturally Aspirated
7
02-12-2006 11:30 AM
1990hondaHF
Honda Civic / Del Sol (1992 - 2000)
3
04-08-2004 11:13 PM