Idle speed setting
#1
Idle speed setting
Can someone give me some pointers on the Idle speed adjustment procedure described in the Helm manual. I gave it a try once and it did not yield any results. I would like to experiment a slightly higher idle speed ( about 1000 rpm) to see if it takes care of an annoying little "almost staling while warming up" problem the car as.
-Did someboby manage to increase it's idle speed over spec with this procedure ?
-Can I actually reach 1000 rpm with the adjusment screw ?
-Is there any downsize at adjusting the idle speed higher then the specs ?
Thank you
If this as already been covered before, just call me a nooby and please point me to the proper link ( I didn't find anything with the search fonction).
-Did someboby manage to increase it's idle speed over spec with this procedure ?
-Can I actually reach 1000 rpm with the adjusment screw ?
-Is there any downsize at adjusting the idle speed higher then the specs ?
Thank you
If this as already been covered before, just call me a nooby and please point me to the proper link ( I didn't find anything with the search fonction).
#2
Honda-Tech Member
Re: Idle speed setting (JPP)
The following combination of things might help:
1)Slightly advanced timing (1 degree or so)
2)Open the throttle butterfly slightly (recalibrate TPS)
3)Open (counter clockwise) throttle body bleed screw
Again, some combination of those things will yeild a higher idle - it's somewhat blackmagic.
1)Slightly advanced timing (1 degree or so)
2)Open the throttle butterfly slightly (recalibrate TPS)
3)Open (counter clockwise) throttle body bleed screw
Again, some combination of those things will yeild a higher idle - it's somewhat blackmagic.
Thread
Thread Starter
Forum
Replies
Last Post