Bigmo5328

91 Acura Integra LS.... Been here before and I'm back again. Currently sitting in the car, But back to the question... Driving home from work this morning and was getting ready to make a turn went to pull off and something snapped and the car wouldn't go. Releasing the clutch and it sounds like something is grinding or flapping around. Press the clutch in and noise goes away. I can put it in gear but nothing happens. Any ideas?

B20VtecVillain

Sounds like a clutch/pressure plate/throw out bearing issue. I would pull the trans and take a look at everything

HondaPartsHero

Check your cv axles

wunfstgsr

Clutch release bearing or pilot bearing most likely or clutch disc broke. Pull the trans and find the culprit.

Bigmo5328

Turned out cv axle snapped..... Any recommendations on after market have to replace this almost once a year.... Others never snapped like this just started making alot noise when turning...

wunfstgsr

look into a drive shaft level 0 replacement axle well worth the money!

egsleepercivic

autozone has lifetime warranty but they are hit or miss... I have gotten bad ones straight out of the box from them

B_Swapped93

used OEM or those part store ones I just went and complained if I got a bad one and they gave me a new one. DSS is fine too no warranty AT ALL tho... among k series guys they're not liked much but if you aren't driving hard etc it's fine.

tamboo

just bought an empire driver's side, it even has the harmonic balancer thing like the honda part.

More Information for EMPIRE 801028