Milled head and new head gasket still leaking
#1
Milled head and new head gasket still leaking
I have a acura with the b18b1 engine in it .. Old head gasket was blown.. So I took head off and had it milled and got a new gasket put it back together and water runs out bottom right hand corner took back apart to make sure nothing was between head and block and put back together same thing ? Any help on this ?
#4
#6
Old Fart
Join Date: May 2004
Location: kelowna, bc, canada
Posts: 26,173
Likes: 0
Received 14 Likes
on
14 Posts
Re: Milled head and new head gasket still leaking
As mentioned, was that with a precision straight edge, or an old carpenters square?
Then if block head is flat then the head must have been machined, [milled] wrong, you installed the gasket wrong, [or it was damaged] or you did not torque the head down properly.
Assuming the head was machined properly and you installed the undamaged gasket properly and properly torqued the head down, it only leaves the block deck.
As an old machinist, [at a shop we service] told me, even a brand new blocks head can be machined flatter/squarer then "stock" he has yet to see one he could not improve. 94
Then if block head is flat then the head must have been machined, [milled] wrong, you installed the gasket wrong, [or it was damaged] or you did not torque the head down properly.
Assuming the head was machined properly and you installed the undamaged gasket properly and properly torqued the head down, it only leaves the block deck.
As an old machinist, [at a shop we service] told me, even a brand new blocks head can be machined flatter/squarer then "stock" he has yet to see one he could not improve. 94
#7
Honda-Tech Member
Join Date: Jan 2008
Location: OR, USA
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Re: Milled head and new head gasket still leaking
Another thought would be to check for any cracks as well. I assume by water you mean coolant. Is it leaking from the front or the rear of the vehicle?
Thread
Thread Starter
Forum
Replies
Last Post
MigsD16
Engine Machining & Assembly
8
12-17-2016 05:17 PM
I8ayellowcrayon
Honda CRX / EF Civic (1988 - 1991)
18
01-29-2004 11:42 AM