owa

I have a b18 from a 95 ls integra and its just sitting on my garage floor. Does anyone know the size of bolt and type of thread so i can bolt it up to my engine stand. thanks in advance everyone.

elf469

should be the same ones you use to bolt the tranny to the engine if i remember correctly...

owa

but do you know what size those are

ef9er0

size as in head of the bolt?? if so i think its a 17

keepinitrehaal

You use the bolts off the tranny, i cant remember what thread pitch they are.

owa

Im just trying to find out what size bolts to buy, cause when i bought the car it came with an extra motor....... but i dont know what size bolts to go out and buy to put it up on the stand. but thanks so far everyone

leteg98

http://www.redliners.ru/temp_foto/oe...ropean_EPC.pdf

check that link its the manual for a euro itr but the bolts are the same

Muskie Man

I bought the factory bolts for the trans and they were not long enough to put one of my b17a blocks on my stand. I am sure not all stands are the same though. I needed bolts 1/2 or 3/4in longer than the factory trans bolts to put my shortblock on my el cheapo checker stand (gift from girlfriend). Sorry this was many years ago so I cannot remember the thread pitch or size I used. Hopefully your stand is better than my cheapo.

egsleepercivic

12x1.25 what ever length you need

PatrickGSR94

iTrader: (1)

Weird, my tranny bolts worked just fine to get my B18C1 onto my el cheapo Harbor Freight 3-wheel stand... unstable as hell but it got the job done. It was a little scary flipping the entire engine upside down (head and IM still attached) with that 3 wheel stand.