01 integra gsr build questions
#1
01 integra gsr build questions
alright iv done alot of research i just want to see other peoples opinions and see if i should make any last min changes.
ENGINE
b18c1 block and head
82mm bore w/ 12.0:1 compression supertech pistons
eagle rods
stock crank
stock valves
skunk 2 valvetrain
skunk 2 pro 2 cams
arp head studs
supertech valve seals
skunk 2 cam seals
oem head gasket
im going to get a engine mount kit as well
INTAKE
skunk 2 intake mani w/ skunk2 throttle body port matched
injen short ram intake
EXHAUST
skunk 2 alpha series headers
skunk 2 mega power exhaust
3 in test pipe.
SUSPENSION
skunk 2 pro c coilovers
blackworks lower control arms.
Basically everything is done except the pistons and the bore.
after i get it done iam going to tune it on hondata and in the future ill throw 50-75 shot of nos.
i just want some opinions of what else i can do what people think of the build
what can i do to the overall car. and how much hp you think ill be at after a good tune
ENGINE
b18c1 block and head
82mm bore w/ 12.0:1 compression supertech pistons
eagle rods
stock crank
stock valves
skunk 2 valvetrain
skunk 2 pro 2 cams
arp head studs
supertech valve seals
skunk 2 cam seals
oem head gasket
im going to get a engine mount kit as well
INTAKE
skunk 2 intake mani w/ skunk2 throttle body port matched
injen short ram intake
EXHAUST
skunk 2 alpha series headers
skunk 2 mega power exhaust
3 in test pipe.
SUSPENSION
skunk 2 pro c coilovers
blackworks lower control arms.
Basically everything is done except the pistons and the bore.
after i get it done iam going to tune it on hondata and in the future ill throw 50-75 shot of nos.
i just want some opinions of what else i can do what people think of the build
what can i do to the overall car. and how much hp you think ill be at after a good tune
Last edited by hideyourface; 12-11-2012 at 02:11 PM.
#2
Re: 01 integra gsr build questions
My build is so similiar,, same cams, everything, cept I have stock rods, 81 mm Nippon pistons on 10.8 compression, made 201 whp and 149 ft tq on a shitty tune by eriks racing. (only took half hr) what im going to do which would probably benefit your build as well, better intake manifold (performer ex, custom made) a better header (hytech/replica, toda/replica, ect) 3" tuned cold air intake with velocity atack, and whatever else.
Thread
Thread Starter
Forum
Replies
Last Post
Eyes Only
Tech / Misc
2
09-15-2003 05:55 PM