FS: 96 JDM Honda ITR - RHD, SoCal, PRICE DROPPED
09-16-2004, 01:57 AM
#1
Honda-Tech Member
Thread Starter
Join Date: Feb 2004
Location: City of Stars
Posts: 529
Likes: 0
Received 0 Likes
on
0 Posts
FS: 96 JDM Honda ITR - RHD/Spoon/Toda
<FONT SIZE="8">
CAR HAS BEEN SOLD!!!!</FONT>
<FONT SIZE="5">-1996 JDM HONDA ITR - RHD-</FONT>
FYI: this car is just right for beginner or intermediate roadracing/autocrossing. In addition, this car will serve it's purpose well as a demo car for a business in the Honda/Acura performance industry. While I was at Inline Four, it was a great tool for advertising/marketing and to gain exposure.
The price is FIRM, so I would appreciate only serious inquires only.
The car has been daily driven(everyday and taken just about everywhere) and tracked a dozen or so times in the time I've owned it. So the engine is tired with approx. 85k miles. The original cluster was damaged last year and I replaced it with another 96spec cluster. This is 100% authentic with the exception of a U.S. windshield(registration purposes).
Flaws: The heater controls are inop. along with the front and rear defrosters. Rear wires to the hatched were clipped as a race hatch was installed(sold). I have an extra rear hatch defroster wiring if needed. A new heater control switch assy. will be needed for heater and defroster to resume working condition. Very few minor dings and scratches. That's about it. Not bad for an 8 year old car.
Ok, now for the mods.
ENGINE: The engine is basically stock(JDM B18C 11:1 compression). Well maintained, oil changed every 3-4k(Castrol Syntec and occasionally Motul) along with plugs every 6k(NGK BKR7E-11). No A/C or power steering. Drop in K&N air filter. Injectors cleaned and flow-tested by RC engineering once a year. FEEL'S 4-2-1 1pc. header with 2.5in collector, FEEL'S test pipe with heat shields, FEEL'S cat-back exhaust(2.5in piping diameter). NGK R09 silicone spark plug wires, Odyssey lightweight race battery. Stainless-steel clutch line. Stock ITR transmission w/ LSD. Toda Flywheel and clutch. Stock ECU. Fluidyne race radiator. Rear race pipe(2.5 dolphin tail pipe replaces axle back section) will be included.
SUSPENSION/BRAKES: Spoon(yellow) dampers, Spoon springs(linear front/progressive rear...old skool black ones). OEM rear lower tie bar, Spoon rear strut tower bar, OEM ITR front tower bar, EM Racing C-Pillar bar, trunk floor bar and trunk wall bar. JDM 98spec ITR rear upper control arms. Custom front brake setup: Rotora slotted front rotors(95 VTEC Prelude 11in), 98 ITR calipers, Axxis Ultimate front pads. This front setup required me to install 5mm Eibach wheel spacers and ARP extended wheel studs. The rear is factory with the exception of AEM brake pads. Motul 5.1 brake fluid used.
WHEEL/TIRE/EXTERIOR: Factory 4x114.3 96spec wheels with Advan Neova AD07 tires(70% tread left), Spoon carbonfiber hood(real).
INTERIOR: Factory interior, gutted rear(still have rear seats if needed). Momo 12.6in monte carlo w/ NRG quick release, ULTRA speed meter. TAKATA 4pt. racing harness. Eclipse CD player, Pioneer speakers.
The paint is in great condition, no accidents.
I am located in So. California. I do prefer to sell it out of state, considering laws and methods have changed with the registration process since I've done it. For out of state buyers, you will assume all risk if any with your local state laws.
Some of you may remember this car from a Honda Tuning cover shot or Import Racer magazine. If you have any questions or comments, I do prefer them via PM or email (bbacio@sbcglobal.net). Please do not call me at work to inquire about the car.
-Brandon
Modified by 110 South at 11:44 AM 9/21/2005
Modified by 110 South at 1:40 AM 10/28/2005
Modified by 110 South at 10:48 AM 10/28/2005
Modified by 110 South at 11:16 AM 12/13/2005
CAR HAS BEEN SOLD!!!!</FONT>
<FONT SIZE="5">-1996 JDM HONDA ITR - RHD-</FONT>
FYI: this car is just right for beginner or intermediate roadracing/autocrossing. In addition, this car will serve it's purpose well as a demo car for a business in the Honda/Acura performance industry. While I was at Inline Four, it was a great tool for advertising/marketing and to gain exposure.
The price is FIRM, so I would appreciate only serious inquires only.
The car has been daily driven(everyday and taken just about everywhere) and tracked a dozen or so times in the time I've owned it. So the engine is tired with approx. 85k miles. The original cluster was damaged last year and I replaced it with another 96spec cluster. This is 100% authentic with the exception of a U.S. windshield(registration purposes).
Flaws: The heater controls are inop. along with the front and rear defrosters. Rear wires to the hatched were clipped as a race hatch was installed(sold). I have an extra rear hatch defroster wiring if needed. A new heater control switch assy. will be needed for heater and defroster to resume working condition. Very few minor dings and scratches. That's about it. Not bad for an 8 year old car.
Ok, now for the mods.
ENGINE: The engine is basically stock(JDM B18C 11:1 compression). Well maintained, oil changed every 3-4k(Castrol Syntec and occasionally Motul) along with plugs every 6k(NGK BKR7E-11). No A/C or power steering. Drop in K&N air filter. Injectors cleaned and flow-tested by RC engineering once a year. FEEL'S 4-2-1 1pc. header with 2.5in collector, FEEL'S test pipe with heat shields, FEEL'S cat-back exhaust(2.5in piping diameter). NGK R09 silicone spark plug wires, Odyssey lightweight race battery. Stainless-steel clutch line. Stock ITR transmission w/ LSD. Toda Flywheel and clutch. Stock ECU. Fluidyne race radiator. Rear race pipe(2.5 dolphin tail pipe replaces axle back section) will be included.
SUSPENSION/BRAKES: Spoon(yellow) dampers, Spoon springs(linear front/progressive rear...old skool black ones). OEM rear lower tie bar, Spoon rear strut tower bar, OEM ITR front tower bar, EM Racing C-Pillar bar, trunk floor bar and trunk wall bar. JDM 98spec ITR rear upper control arms. Custom front brake setup: Rotora slotted front rotors(95 VTEC Prelude 11in), 98 ITR calipers, Axxis Ultimate front pads. This front setup required me to install 5mm Eibach wheel spacers and ARP extended wheel studs. The rear is factory with the exception of AEM brake pads. Motul 5.1 brake fluid used.
WHEEL/TIRE/EXTERIOR: Factory 4x114.3 96spec wheels with Advan Neova AD07 tires(70% tread left), Spoon carbonfiber hood(real).
INTERIOR: Factory interior, gutted rear(still have rear seats if needed). Momo 12.6in monte carlo w/ NRG quick release, ULTRA speed meter. TAKATA 4pt. racing harness. Eclipse CD player, Pioneer speakers.
The paint is in great condition, no accidents.
I am located in So. California. I do prefer to sell it out of state, considering laws and methods have changed with the registration process since I've done it. For out of state buyers, you will assume all risk if any with your local state laws.
Some of you may remember this car from a Honda Tuning cover shot or Import Racer magazine. If you have any questions or comments, I do prefer them via PM or email (bbacio@sbcglobal.net). Please do not call me at work to inquire about the car.
-Brandon
Modified by 110 South at 11:44 AM 9/21/2005
Modified by 110 South at 1:40 AM 10/28/2005
Modified by 110 South at 10:48 AM 10/28/2005
Modified by 110 South at 11:16 AM 12/13/2005
09-16-2004, 09:18 AM
#6
Join Date: Nov 2003
Location: Lakewood, CA, USA
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
Re: (110 South)
I would hate to see it go. I need to drive it one last time before you sell it. 
Very fun car to drive, and you cant go wrong buying from Brandon. Great guy to deal with. ( since I have to everyday
)
Very fun car to drive, and you cant go wrong buying from Brandon. Great guy to deal with. ( since I have to everyday
)
Trending Topics
09-17-2004, 08:59 AM
#18
My old title sucked.
Join Date: Nov 2003
Location: Out to lunch. WI
Posts: 5,568
Likes: 0
Received 0 Likes
on
0 Posts
Re: FS: 96 JDM Honda ITR - RHD (cryptikman)
This intrigues me. 
No set price huh, just make an offer. Trade for a ZC civic wagon? J.K. In all seriousness I'll get back to you in a day or two.
No set price huh, just make an offer. Trade for a ZC civic wagon? J.K. In all seriousness I'll get back to you in a day or two.
09-18-2004, 06:16 AM
#23
Honda-Tech Member
Re: FS: 96 JDM Honda ITR - RHD (mikehonda)
bump for early morning brandon. 
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by mikehonda »</TD></TR><TR><TD CLASS="quote">mikehonda: who'll prolly sell his too</TD></TR></TABLE>
kepani-who hopes he'll keep his too...
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by mikehonda »</TD></TR><TR><TD CLASS="quote">mikehonda: who'll prolly sell his too
</TD></TR></TABLE> kepani-who hopes he'll keep his too...
