Before anyone goes off and says buy a b16 or d16z6 hear me out. My buddy just picked up a 95 dx for dirt cheap. Anyway, i have my old zc motor out of my crx at the shop and we thought just for ***** and giggles since a motor swap only take and hour that we would through the zc in the eg because he needs to replace hi sInput shaft bearing. My question is do we use the eg mounts?? i know we will just use his intake manifold and exhast manifold just whihc mounts?? Just thought we would try a little project since we can.

 

Sohc manifold will not fit on dohc ZC. I asume you'll have to figure out how to modify the mounts so that they'll fit on the ZC motor, but you probably already knew this.

 

all d series intake and exhaust manifolds are the same. aren't they......

 

No. The dohc D series intake manifolds are not compatible with the sohcs. This applies to the ZC engine and the D16A1 Integra engine.

 

Would the dx sensors off the eg transfer over to the zc mani?? and we could just use the stock dx injectors so we wouldnt need a resistor box??

 

cmon mr. s