sup all i just wanted to know if anyone has done a mini-mewith the vx block?? is it worth going through the hassle? if i run it im going to use a z6 head single ply z6 gasket and the basic i/h/e..so will it be potent? or should i just find a better block to play with?

 

You will definently see a difference, but if you have the money look for a better block.

 

get the ex/si tranny too. i cant remember the tranny code for it but a lot of people say the mini me is near worthless without the ex/si tranny. good luck with it, i'll be doing a z6 mini me on my dx soon, tranny to

 

well this is all going into an ef, so im going to be rocking a zc tranny, so its better to find a dx block or something other then the vx?

 

READ THIS: https://honda-tech.com/zero...age=4

We played around with the idea of a mini-me on the VX block...problem is, the VX pistons have a 7.50mm dish which would make the compression INCREDIBLY low and would counteract the gain in HP from the VTEC head...Mini-me on a VX will NOT work unless you change the pistons

Read the rest of my writeup too (all 4 pages...lots of good info) link is in the sig as well

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Nerologic &raquo;</TD></TR><TR><TD CLASS="quote">well this is all going into an ef, so im going to be rocking a zc tranny</TD></TR></TABLE>

my bad on the into ef, i assumed into a 5th gen. BauleyCivic, i'll most likely be PMing you once i start my mini me swap.

 

heh alrighty man

 

alright cool im going to skip that idea and look for anther block that better...what would be the desired mini-me block by the way?

 

D15B7...flat top pistons, better R/S ratio than a D16Z6...

the best mini-me setup is P29 D16A1 pistons with VX rods in a D15B7 block with a D16Z6 or D16Y8 head...

or you could simply do any D16 block with the stock rods and P29 D16A1 pistons

 

any time you do a mini-me....you should also do tranny to reap the benifits of vtec and the added horsepower

 

i'll second that!!!!!! my trans is going in saturday!!!!! finally!!!!!!1

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by BauleyCivic &raquo;</TD></TR><TR><TD CLASS="quote">
or you could simply do any D16 block with the stock rods and P29 D16A1 pistons</TD></TR></TABLE>

That is probably the best option, no reason to fish around for VX rods when they are the same length as d16 rods, plus does anyone know if the VX rods are just as strong as say the d16z6 rods.