I bought the car like this, and can't get ahold of the previous owner, and I already searched. On my 89 Civic, I have a different suspension, front and rear. The rear are disc brakes, but not sure what car they are from. The front is my main concern though...

Driver side - KL14 3FF
Passenger side - KR14 OK3

This was printed on the front of the steering knuckle; does anyone recognize this? I spent about an hour in the back of Auto Zone trying to find a wheel bearing to fit this... The bearing for the car was too small by a little under 1/4". I can get serial codes off of the brake pads later if that would help anything. Thanks in advance!

 

I cant help you with just the part numbers. Try getting some pics up, and I am sure someone will be able to help. Alot of the popular swaps are the EX, and integrea setups. Look into them if you can.

 

My camera isn't working right now... I'll try to borrow my friends camera tomorrow. I was just thinking maybe someone would have recognized those numbers on their suspension.

 

Here's a pic that I scanned, but isn't all that great.

 

Anyone?!?! Should I put a link in the Teg forum?

 

Measure the brake rotor diameter, if it is 10.2 you have EX or Integra knuckles. If its 9.5 than its just Si or DX, and I think STD has even smaller ones.

 

From the markings, it's not an EX or integra knuckle.

 

The rotor is 10.25"....

 

Sounds like they are DA knuckles, just looked at the set in my basement, they are marked KL-14 and KR-14

 

Right on man. Thanks.

 

Jared I owe you a gargantuan thumbup. I almost went to a junkyard to buy some DX hub assemblies or Si if I could find them. I ordered a DA wheel bearing and it fit perfectly. Thanks!