greddy turbo kit install on d16d6 civic
#2
Honda-Tech Member
Join Date: Mar 2002
Location: Kansas City, MO, USA
Posts: 1,428
Likes: 0
Received 0 Likes
on
0 Posts
Re: greddy turbo kit install on d16d6 civic (vtectuner99)
black box
white------------------------>white map sensor
red-------------------------->yellow/red map sensor
black------------------------>green/white map sensor
blue------------------------->white ECU wire
green----------------------->2 green/white wire (ECT & IAT)
wire colors are denoted by the solid wire color first and then the striped color (if any)
steps
1. cut the white wire at the map sensor. SPlice the white wire from the sensor to the white MAP IN wire from the black box
2.Connect the blue CLAMPED MAP OUT wire from the black box to the white wire running to the map input to the ecu
3.Use t-tap splices to connect the red +5V POWER wire from the black box to the yellow/red wire to the map.
4.Use T-tap splices to connect the black GROUND wire from the black box to the green/white wire to the map sensor.
5.Make connections at the air and water temperature sensors. Cut the green/white sensor GROUND wire at the Intake Air Temp (IAT) sensor and Engine Coolant Temperature (ECT) sensor. Tape up the ends of the wires running back to the honda ECU. Splice the two ends of the wires running to the sensors to the green SENSOR return wire from the Black Box.
These were taken straight from the greddy instal manual. I hope it helps.
white------------------------>white map sensor
red-------------------------->yellow/red map sensor
black------------------------>green/white map sensor
blue------------------------->white ECU wire
green----------------------->2 green/white wire (ECT & IAT)
wire colors are denoted by the solid wire color first and then the striped color (if any)
steps
1. cut the white wire at the map sensor. SPlice the white wire from the sensor to the white MAP IN wire from the black box
2.Connect the blue CLAMPED MAP OUT wire from the black box to the white wire running to the map input to the ecu
3.Use t-tap splices to connect the red +5V POWER wire from the black box to the yellow/red wire to the map.
4.Use T-tap splices to connect the black GROUND wire from the black box to the green/white wire to the map sensor.
5.Make connections at the air and water temperature sensors. Cut the green/white sensor GROUND wire at the Intake Air Temp (IAT) sensor and Engine Coolant Temperature (ECT) sensor. Tape up the ends of the wires running back to the honda ECU. Splice the two ends of the wires running to the sensors to the green SENSOR return wire from the Black Box.
These were taken straight from the greddy instal manual. I hope it helps.
Thread
Thread Starter
Forum
Replies
Last Post
Gant
Honda CRX / EF Civic (1988 - 1991)
6
05-18-2005 08:47 PM