I found this post when searching, but just wanted to verify:
https://honda-tech.com/zerothread?id=176526&page=1

The last few people said they were hard to get, or expensive.
Where can you get the handles besise the dealer?

Also, the part number is: 72125-ST7-023ZA correct?


[Modified by jond, 9:01 PM 6/5/2002]

 

This might sound like a dumb question, but are those the outside handles or the inside?

 

inside handles.........

they range from 6-15$ at the dealers so your best bet would be there. You might find it alittle cheaper on some internet sites, but its just not worth the time to me. I don't know of any sites though.


[Modified by tjtruong, 2:19 AM 6/6/2002]

 

Should be about $7 per side. And yes, they may be back-ordered.

[edit] Part numbers for j00...





[/edit]


[Modified by itr009, 12:42 AM 6/6/2002]

 

just buy them from the dealer....unless you can find a LS teg properly unequipped with electric locks in a junkyard....but it's not worth the energy, unless your delaer can't get them for you.

Cheese~

 

what about outside handles? are there any that will fit that dont have key holes on the outside?

 

the rear handles off of a 4 door.

Will

 

How hard is it to install these? Are they as simple as popping off the stock ones and putting the new ones in? What do I do with the wires? TIA

 

I took the old connector for the power door handles and wrapped them in soft foam and then taped them to the inside of the door so if I ever needed the connectors again, it would be easy to get them.

Then you just pop in the new ones with a screw and you are done.

Super Simple. Even itrsport.com could figure it out ;-) j/k

 

What is the reason for removing the power locks? How do the theives use the power locks to their advantage?

 

You can try here:

http://www.haprecycling.com

They usually have what I need.

 

i'm a total n00b here but, why are we installing these on itr's again?

 

cause they don't have the power door lock switch. The switch aids thieves in entering your cars.

 

yup...and the outside ones w/o locks A...look better...B) Provide no lock to pick/drill....

 

So would it be more beneficial to just do the outside key hole fill/or switch it with the rear 4 dr. handles?

For a body shop to fill the key hole should cost much.