Hi guys,

I was wondering how hard it is to install 93 GS integra seats in a 91 DX? Anyone have detailed information on this? Websites maybe?

Thanks!

 

use your old bracket from your civic .. youll have to weld take one seat out to make sure they will fit.. i had a buddy buy some newer civic seats and they wouldnt even fit in the car .. haha..

 

Has anyone done it?

 

I'm putting some in my 91 Civic hatch right now,they're out of a 92 Integra.Despite what you may have heard or read on the internet,it's not that bad.Here's the deal:
*Take your stock seats out of your Civic
*Remove the OUTER (next to door) rails off the stock Civic seats and Integra seats and swap them.
*Adjust the wire that connects the tracks while the seats are out,it's easier that way.If this is done incorrectly,your seats won't slide back and forth.You may have to adjust until they slide.
*Put the Integra seats in your Civic,you should be able to bolt up 3 of the mounts to the floor (the two fronts and outer (door side) rear.
*You'll notice that the rear mount next to the console doesn't line up and there is a gap there....don't freak...the easiest way to do this is to drill a hole in the mount next to the stock hole.Don't drill out they floorboard!I suppose you could,but then you'd have to use a tap to thread it.Use your own judgment here,and try to get the hole directly above the hole in the floorboard.I used a 1/2 drill bit.Get two M10 bolts with a 1.25 thread pitch about 3 inches long and a few spacers.You may have to enlarge the hole you made in the mount to get the bolt lined up with the hole.Then just use some washer/spacers under the mount,put your new bolt in and tighten her down.Your done I used the outer trim from the stock Civic seats...you'll have to take off about 1/2 inch where the recline handle goes.If you have any questions,email me at trox959@yahoo.com and I'll be glad to help.Enjoy the Teg seats!

Glenn
91 Civic hatch

 

why go through all the trouble when you of taking one side of the rails off....if you want take both of the rails off and then work from there.....I have taken the rails off my seat and places them on a civic and it fits like it was stock....I will take pictures of them as soon as I can figure out how to post pictures.....CAN ANYONE HELP PLZZZZZ........

 

The inner (console) rails of the 90-93 Integra seats can't be swapped with the Civic rails because the Integra rails also bolt to the seatback,the Civic rails won't.I'll have pics of my 92 Integra seats in my 91 Civic soon,just use the inner Integra rail and the outer Civic rail like I described above,drill you a mounting hole in the rear inner mount,and you're done.This is the easiest way to do it,and the seats will still fit a 90-93 Integra should you decide to sell them.

Glenn


[Modified by subgeniusdude, 6:39 AM 10/31/2002]

 

its easiest to drill new holes and run bolts thru. dystroys your car but hold in the seat . its quite humerouse to see all the holes from variouse seats ive had in

 

You could do it that way,but on 90-91 Civics,that metal in the floorboard is about an inch thick where the seats bolts go in,but on the mount its only about 1/8.Why drill holes in your floor when you can just drill another hole beside the stock hole on the mounting tab?You can do it anyway you like,but I dont prefer to have a swiss cheese floorboard

Peace,
Glenn