I'm selling my 1994 Integra LS with LS/VTEC setup. I just finished the build late June, but I need the money for school. Everything I put on, i.e. suspension, engine junk, etc. is brand new and not even a few months old. I have paperwork for everything I purchased and you can see the dates I purchased them on. A LOT of people in the Chicago Burbs can vouch for my car. Charlie from Top Setup helped me finish the build and he tuned my ECU. VTEC hits strong and hard. VERY LITTLE rust on rear quarter panel, the size of a quarter. I painted over it so it doesn't look whack. The exedy clutch is slipping a bit, but no harm there. Again, I'm going full time this year in school, and so I'm quitting my job, and I can't let car building hinder me any longer. Feel free to email me, or call me to check out the car or if you want more pics of specific things. But everything's there. I pulled the AC, but I still have it here in my garage if you want it. Power steering is installed, but I haven't gotten around to putting the belt on yet. The new motor and everything roughly has about 1000 miles on it.

email me: pjcatanus@gmail.com
AIM me: pjcatanus
mobile me: (630)400-0258

I just registered my car, so i'm waiting on the title still.
I'm asking 6000 OBO....NEW PRICE!!!!

Engine:
-LS/vtec setup:
-LS Block (decked, cylinders honed, and line honed)
-LS Crank (fully balenced and micro polished)
-New Main Bearings
-New Rod Bearings
-New Thrust Washers
-LS Rods
-LS Pistons
-ARP Rod bolts
-New OEM Main Bolts
-New OEM Piston Rings
-ITR Oil Pump
-GSR Timing Belt
-AEM Fuel Rail
-LS Injectors
-GSR Cylinder Head
-Skunk2 Intake Manifold NEW!!
-Skunk2 68mm Throttle Body NEW!!
-Top Setup custom 3" short ram intake NEW!!
-B16a Cams
-GSR Water Pump
-New GSR Crank Pulley
-Hondata Head Gasket NEW!!
-ARP Head Studs
-GSR Power Steering Bracket
-ITR Throttle Cable NEW!!
-DC Sport 4-1 Ceramic Header
-Test Pipe
-Skunk2 Exhaust NEW!!
- ~1000k on newly built motor


Transmission:
-1999 Civic Type R trans (with LSD) ~40k
-ACT 6 puck clutch plate NEW!!
-Exedy ~9 lb Flywheel
-Exedy Stage 1 Clutch
-New Throw-out Bearing
-OEM Honda Manual Trans Bracket
-Manual Pedal Set
-Clutch Master Cylinder and hard lines
-Shift Boot and Surround w/ custom metal work
-New OEM Slave Cylinder
-New OEM Slave Cylinder Soft Line
-Manual Transmission Starter


Electronics:
-Apex'i VAFC-II (not installed)
-Kenji B18C ecu (Top Setup tuned)


Suspension:
-KYB GR2 shocks NEW!!
-Ground Control/Eibach coilovers NEW!!
-BEAKS rear lower tie bar
-Prothane Strut Bushings
-ARP Extended Wheel Studs


Wheels & Rubber:
-15x6.5 Rota Slipstreams (full polish finish) NEW!!
-205/50/15 Falken Ziex (brand new) NEW!!


Brakes:
-Axxis Semi-Metallic Pads
-New OEM Master Cylinder


Interior:
-G1 Teg shift ****
-Dual Gauge Pod
-Oil Pressure gauge (not installed)
-Air/Fuel Ratio gauge (also not installed)


Exterior:
-APR Carbon Fiber Mirrors


Weight Reduction:
-Removal of Sound Insulation (hatch area)
-Removal of AC (still have)


Pics:






















i'll put up more pics tomorrow morning.
thanks for looking!!!!


Modified by hothotpete at 6:15 AM 7/22/2006


Modified by hothotpete at 12:58 AM 7/25/2006

 

bump for tonight

 

bump

 

damn...this is what i want to build...the only thing i dont like is the rust and the auto-manual trans swap

 

4th pic down, see the minor rust (bubbles) above the wheel well. it's honestly not bad at all. but thanks for the bump!!! very clean car, i just need a daily driver now. (SOHC). TTT!!

 

yes i noticed the rust

good luck with sale and the SOHC!!!

gas is supposed to be $4 a gallon by the end of this mont

 

dang, $4. ghey. i need a hybrid. thanks for the bump

 

NEW PRICE!!!! 6000 OBO!!!!

 

trade for a SOHC rex Si? gets about 34-39 MPG :-p pm me back or e-mail me at civicxman103@yahoo.com

 

trades?

 

trades are good....but i want a stock car + cash cause UTI is expensive.

SOMEONE BUY IT!!! bump!!!

 

bump for tonight

 

buyyyy meeeee

 

will accept trades + cash.....pref stock cars or a motorcycle ;-)

 

hello?

 

pre-work bump

 

still for sale....cmon, anyone?????

 

Bump for a clean swap

 

thanks for the bumps. SOMEONE BUY IT!!!!

 

part out the shell? pm me

 

BBBBUUUUMMMPPPP

 

bump good luck