my 89 si sunroof doesnt open or close via the switch it does open and close via allen wrench i pulled the headliner down and put power to the motor with jumper wires and to motor works so i have no idea what to do next?

 

Take the switch apart and clean or replace it. You have checked the fuse?

 

yes ive checked the fuse

 

it means, ur sunroof needs a new owners

 

dont hate me cause i bought an 89 si with 77,000 and no rust for $600

 

holy ****, i wish i had that deal

 

pulled the switch apart everything apears to be in good working order

 

jus get a new switch at the junkyard or something. or buy one from ebay

 

i tried to jump the circuit out but not sure if im doing it right i think im chasing my tail here

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by wood 1 &raquo;</TD></TR><TR><TD CLASS="quote">Take the switch apart and clean or replace it. You have checked the fuse?</TD></TR></TABLE>


Ding , Ding Ding !!!
We have a winner folks !
I'm with this guy.

 

yea replace the switch. had the same problem and that fixed it.

 

i think the switch is fine i ohmed it out and appears to be fine does anyone have the wiring diagram

 

from the FAQ section:
http://mirror.rivendel.nu/crxc...f.pdf

*requires adobe acrobat reader

 

There's a clutch on the motor.

Assuming the motor turns when you hit the switch, you need to tighten the clutch.

Do a google search for "crx factory service manual" there's a section in the FSM on how to tighten the sunroof clutch.

-Des!

 

ok let me be a little more clear when i unplugged the sunroof at the motor and put power right to the motor and it opened and closed. i pulled the switch apart everything appears to be fine.either im not getting power to the switch or theres a break in the wire.i just want wire colors going into the plug

 

the switch will look fine and be garbage, it's the problem 99% of the time

 

i tested it at work on a volt ohm meter

 

check for voltage on the plug for the motor...contacts could be dirty.

My switch was also bad, but I cleaned the contacts on the inside real good and made sure the touched when the switch was pushed and that fixed my problem as well...hope its something that simple with yours!

 

See quote below:



Modified by 88DXCRX at 1:47 PM 5/25/2006

 

see thats what i needed ill let u know how i make out

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 88DXCRX &raquo;</TD></TR><TR><TD CLASS="quote">Click on the pic and after it loads,click again for full size:





</TD></TR></TABLE>


**** man where did you get that?
i need that same thing, my sunroofs got problems too

 

Helms factory service manual and a scanner...

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 88DXCRX &raquo;</TD></TR><TR><TD CLASS="quote">Helms factory service manual and a scanner... </TD></TR></TABLE>
88DXCRX = Honda Tech Helms hook-up

 

alright guys thanks for al your help it was the relay