so i'm doin my swap and it's time to switch A17 to A20 and i'm taking an A/C pin to use for the knock sensor, but how the **** do you get the pins how? i used a needle nose and released the little clip things on the top/bottom of the ECU clip, and i tried using a tiny screw driver and put it in and wiggled both the wire and the screwdriver and pulled just a little bit and nothing happened? i tried the paper clip and that didn't work? is there some special way to do it or something? wtf....

 

need any info ASAP...

 

ok ****** seriously this **** is gay..... is there a certain way to push in the small tip that your using and wiggle it free or what? cause this is frustrating... all i need is 2 of them to come out that's it....

 

ok got it.... thanks anyways

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by j0nptw &raquo;</TD></TR><TR><TD CLASS="quote">ok got it.... thanks anyways</TD></TR></TABLE>

You are very welcome

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Turbogixxer &raquo;</TD></TR><TR><TD CLASS="quote">

You are very welcome </TD></TR></TABLE>

 

Courtesy of KATMAN