I need to know which bolts/nuts to tighten in what order. Also, should I use gasket sealer on both sides of the gasket, on the whole gasket? or just the corners? Would I be fine reusing a gasket thats been on the motor for maybe 3 days?

 

Bump it up

 

I use hondabond on both sides of the gasket, all the way around. I put the pan in place and tighten all the nuts and bolts finger tight, so they just touch the pan. Then, starting in the middle of one side, I tighten a bolt to the 9 ft/lb spec, then the one on the opposite side. I go back and forth around the pan until i get back to the first one, then I go around one more time, just to double check it. Never had a leak on the many I have done.

You should be ok to reuse that gasket, a few days won't hurt it.

 

10 ft-lbs and apply liquid gasket to 4 points on the oil pan. At where the pan starts to curve downward on each end. apply the liquid gasket on both corner top part of the curved section on both sides.