welding/cutting question
Thread Starter
Honda-Tech Member
Joined: Jun 2006
Posts: 240
Likes: 0
From: san jose, ca, united states
welding/cutting question
Hi, first off, i am clueless about welding. I need to replace my quarter panel on my 93 civic hatch and want to do it myself. i need to know 3 things
What method of welding should i use to weld on the new quarter panel?
Where do i purchase this type of welder that i should use? and whats a good welder for it? like brand, power, ect..?
What type of cutting tool would i use to cut out my original quarter panel out?
What method of welding should i use to weld on the new quarter panel?
Where do i purchase this type of welder that i should use? and whats a good welder for it? like brand, power, ect..?
What type of cutting tool would i use to cut out my original quarter panel out?
Joined: Jan 2005
Posts: 88
Likes: 0
Re: welding/cutting question (r3sgtec)
drill out the spot welds and use a air chisel or a hammer and a flat screw driver/ chisel to seporate the peices... but dont bend the crap out of it make sure all of the welds are cut out ,.. then tack it the new piece in with a mig ,... take ur time and set it up DONT RUSH IT !
Honda-Tech Member
Joined: Jun 2004
Posts: 2,403
Likes: 0
Re: welding/cutting question (r3sgtec)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by r3sgtec »</TD></TR><TR><TD CLASS="quote">what do you mean by TACK the new one to it? </TD></TR></TABLE>
Small welds.
Small welds.
Thread
Thread Starter
Forum
Replies
Last Post
Eighty-Nyne
Honda CRX / EF Civic (1988 - 1991)
10
Jun 25, 2008 04:09 PM