For wiring an ecu, hasport says, To orient the plugs properly when using this diagram hold the plug with the wires facing away and the clip on top. Ok so I made this picture to better explain my question, when I am listening to hasport do I look at side A or side B ?



Side A is like the back of the clip where the wire goes into the clip, and sie b is like where the wires go into the ecu.


[Modified by 90blackcrx, 4:25 PM 2/4/2003]

 

B

 

to figure out pin #s you look from side A.

 

So is it side A or side B, I thought it was side A.

 

sgT is right, for the pinouts you look from side A, but from HASport's instructions it seems like B

Whatever, just use A


[Modified by raene, 11:41 PM 2/4/2003]

 

But if you look at them from side B the wires would be coming at you, but if you look at it from side A, the wires are going away from you. So for hasport instructions is side A right.

 

Anyone else.

 

side A to figure out the pin outs.

EDIT: I'll try to explain here, for C12 (pinout) you would look at the C clip, point the clip as though you are goining to plug it in to an ecu that is in front of you (so all the wires are between you and the clip) then look at your pin out chart and find the location on the clip.


[Modified by 90_Civic_Hatch, 1:54 AM 2/6/2003]