Ok ive had this water temp gauge forever but never installed it because i couldnt find anywhere the sensor would fit. Anyone have a clue on where i could tap for it, or is it useless? Also whats normal operating temp for a gsr?










Modified by ferio 95 at 6:46 PM 1/9/2005

 

Take out the Stock sensor *its in the head under the distrubotor*... and replace it with the new sensor .... then you new guage will work and the stock honda one will not ....

 

wont fit tried it already

 

what about the coolant drain bolt in the back of the block? does it fit there?
just a thought

 

you mean the huge *** bolt????

 

?

 

yea that bolt on the back of the block maybe it might fit there

 

Using the upper radiator hose, you can fab up a small pipe and weld in a bung that will accept the fitting you have.

 

heres what I did. I ordered the hasport K-series coolant sensor adapter and used a couple brass fittings( found at a local hardware store) and made the autometer sensor fit inside that hole.

 

do you have any pics, Big Rich????

 

 

thanks a lot that makes it seem easierthen what i was thinking of