vafc question
Thread Starter
Junior Member
Joined: Apr 2004
Posts: 11
Likes: 0
vafc question
I'm trying to install a vafc-1 on a non-obd b16a with a pr3 ecu. I can't get a signal for pressure. I have it wired to pin c09, input and output are wired correctly, also ecu isnt throwing any codes, any suggestions
**edit*** found a discrepency from hybrid honda's pinouts vs hondata's pinouts for the pr3 ecu. hybrid honda's pinout http://tech2.hybridgarage.com/...pr3_a
says c9 is the only pressure source, hondatahttp://www.hondata.com/techwiringpw0.html says c11 is the correct source while hybrid says its a ground. Also c11 agrees with apexi's documentation so i will try c11 tomorrow and see if it works.
*edit2* c11 is the correct pin for the pr3 if you want to be sure test it with a multimeter before you cut it should read 2.5 volts(DC) with engine off and igniton on
Modified by 1slohatch at 1:20 PM 10/9/2004
**edit*** found a discrepency from hybrid honda's pinouts vs hondata's pinouts for the pr3 ecu. hybrid honda's pinout http://tech2.hybridgarage.com/...pr3_a
says c9 is the only pressure source, hondatahttp://www.hondata.com/techwiringpw0.html says c11 is the correct source while hybrid says its a ground. Also c11 agrees with apexi's documentation so i will try c11 tomorrow and see if it works.
*edit2* c11 is the correct pin for the pr3 if you want to be sure test it with a multimeter before you cut it should read 2.5 volts(DC) with engine off and igniton on
Modified by 1slohatch at 1:20 PM 10/9/2004
Thread
Thread Starter
Forum
Replies
Last Post