ok, so this just happened. I was going down the highway doing 55 slowing down for a car. I put it in 3rd to slow down, after the car turned I kinda got on it in third. I didn't take it to redline but I took it to about 5500. I missed going into 4th for being just stupid lazy and not paying enough attention I guess. Well when i missed it over reved to about 9500 or so because I pressed on the gas pedal waaaay to hard. I pulled off to the side of the road and the car sound like it was "chugging". I drove it back home and it still felt like it had the same power and it didn't really feel any different. I also noticed that the motor seemed like it was shaking more when it was running. Any Ideas would be greatly appreciated do yall think bent valve?

its a JDM GSR


Modified by 92b18c1hatch at 11:43 AM 6/6/2007

 

shi....9500 is pretty high. JDM gsr doesnt rev that high does it? r u chipped?? just curious. Oh and sorry bout your dilemma. *bump* for you.

 

yeah, its a chipped p30. It feels like its lobing when its idleing. pretty much shaking the whole car.

 

Sounds like bent valves. Sucks.

 

yeah, sometimes when the valves make contact w/ the piston, it will still run and drive but have only a little pwoer loss and idle like ur describing.

Sucks mang.

 

expletive! ok thanks guys

 

check compression

 

ok, I will. Is it ok for me to drive the car around for a little while?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by B18C_EH3 &raquo;</TD></TR><TR><TD CLASS="quote">ok, I will. Is it ok for me to drive the car around for a little while?</TD></TR></TABLE>

broken ring land or touched up some valves...

i'd not drive it around like that, but ideally you "could" drive it up until it won't start lol