My timing belt pulley (#16) seems like its fused to the to the crankshaft.
The pin doesn't even slide off ! Anyone come up with a good technique to
remove this when its fused like this ?

http://www.hondaautomotivepart...ISTON

You can't even slide a screwdriver between the pulley and the oil pump.

 

okay, take wd-40 and spray it a little, then tap it with a hammer or rubber mallet. Then just slowly try to slide it back and forth. Sometimes they can be lil bitches, but if all else fails just start beating on it with a hammer and that will loosen it up.