Starter showing low voltage (3-4 volts) and battery is fully charged and not loosing power. Any ideas of what the problem is?

 

btw starter is in good condition.

 

check the cables over again going to the starter

 

GOT IT!!! It's been sitting for over a month and I finally got it pinned. A multi-meter sure is a life saver. I can't believe I didn't think to put the meter on the remote wire of the starter first. Anyways, the ignition switch was the culprit. I just pulled it out cleaned cleaned all the contacts with an emery board, greased the internal casing, and stretched out the springs. I am so pumped that it runs.

Thanks to all that contributed!!! H-T is the shizznit!!!