i just put a d16z6 into my 92 cx
i am getting no spark
i changed the distributor coil with the msd setup
i hooked everthing up rechecked over and over again still i get no spark
any suggestions?

thank you

 

Check the wire that goes from the igniter unit to the coil. That wire is a signal wire for the coil to spark. If you put a test light on there while you are cranking the motor, it should blink, as though the motor is firing. Of course, you will need to remove the distributor cap to do this test, but if you get no blinking, you need a new igniter. About $100-$120 at the dealer....

 

im getting juice to the distributor
im not getting any spark still and no fuel from the pump, it doesnt turn on

im confussed?

 

it could be your main relay