im looking at doing a crvtec setup, and i pretty much have it locked. heres what my setup is pretty much going to be like. what do you guys think the HP/TQ figures will be.thanks.

B16a Head w/ port and polish
Jun Stage 3 Cams w/ valve springs, retainers
ITR intake manifold
Over Bored TB
RC 270cc injectors w/ fuel regulator
AEM Cold Air Intake
B20 block
ARP Stud Bolts
Eagle Rods
JE high dome pistons 11.5:1 cr
Z10 girdle
New bearings throughout

this will be in a EG hatch for pretty much street/strip use....

 

oh and i forgot to add that i will be using a Type R oil pump and the crank will be knife edged....thanks

 

I couldn't guestamate the hp. But it will be quick... Thats for damn sure!

 

I'd clay that first. Those clearances will be real tight. It might not work with those cams and pistons.

 

i think if it doesn clear it would be barely... someone i know with a gsr... had 12.5:1 comp and i forgot what cams... some high lift ones and he was tapping the pistons

 

ookok, what if i used some CTR / ITR mismatch cams....with the initial setup, over the Jun products. thanks