i cant seem to fit the type r shift **** onto my skunk2 shifter... does it fit on there? or do i havta get a skunk2 shift **** now?

 

it should fit, make sure neither one are stripped or anything

 

I have a Skunk 2 shifter in my Civic with a JDM ITR/CTR shift **** - it is a bit tricky - you have to line it up perfectly like a lug nut on a stud. Clean the threads out with a wire brush and try lubing the threads with Never Seize or another lubricant. Make sure it is lined up properly.
If it doesn;t work, just bite the bullet and get the Skunk 2 shifter ****.

 

it should fit....mine does.

 

My friend bought a skunk2 shifter and ****. They're a tight fit.

 

Forget that hard crap! Just put some weight on it and start screwing!

Warning: This may cause rethreading of components. Do not perform if you EVER planning on changing either item.

 

i had the problem with my skunk2 shifter and i had the skunk ****! wouldnt go on.. turned out the coating on the shifter was too thick so i had too get a tool too peel off the coating on the threads screwed in perfect now try that.