i was wondering if this set up would work
if i take a braided line form the back of the block (oil pressure sensor) to and inlet of an oil cooler and from the outlet of the oil cooler to the oil pan
please let me know thanks
jason

 

no, use a sandwitch adaptor to feed the oil to the cooler.
stan

 

why wouldn't it work

 

you want to feed your engine cooled oil, if used properly, by interrupting the flow of the oil between the oil filter and the block and redirecting it to the cooler you are feeding all the oil to the cooler and to the block, where in the case of feeding the cooler partial flow from the sender location you not only impede the flow as the sender orifice is much smaller than the oil filter orifice, but also mixing the cooled oil with the hot, used oil in the pan.
incidentally a proper way to feed the turbo with oil is similar to the cooler routing.
stan

 

ok now i see thanks