alright so im doing the dpfi to mpfi obd1 swap so my question is when i im converting the dizzy wires can i make my own jumper harness without using the plugs and just straight solder them to each wire? or do i have to use the plugs?

 

you can solder them but twist each wire and make sure it works good first before soldering.

i did the same swap dpfi-mpfi, obd0-obd1. but i converted my chassis harness to a obd2a plug. 6 months i got a code 8, needing a dizzy change. a year later got a code 9, needing another dizzy change. im glad i swapped my chassis harness so dizzy's were direct swap

not saying youre going to have the same bad luck i was having, just saying im glad i took the time and did it right

 

yea alright this is just temporary until i can find si dizzy connectors there really not common but thanks

 

btw all those wires from the harness will go to the obd1 female plug so that what i was asking but thanks