I just installed an msd 3bar on my integra using hondata's write up. The voltages check out to 1.59 between the ground and the map signal with the key on. But i can't crank the car on crome pro, and yes i've changed it to a 3bar map. The car will crank and rev for a second, then it'll die. Is there anything that i'm missing? I've got a datalog that I can attach if someone would like to look at it.

All I did was remove my GE vac log and drill out another hole, and add the line there for the map.

 

nevermind. I'm not sure what happened, but I changed to crome2.0. After that everything worked out fine.