I'm in the middle of a project and am preparing to prep the engine bay for paint. Before I got on, I wanted to remove the power steering components (cooler, lines, resevoir, etc.) and loop the lines. Here's my problem. The rack has a line (or two? not sure car is at my shop) that runs to the speed sensor for what I presume is lubrication. I was just going to loop the lines that run to the pump but I'm unsure what to do about the speed sensor line(s). Any help would be great! Thanks guys.

edit-I was also wondering if anyone knows the thread pitch required for fittings in the rack? I can look later but if someone knows, that would be helpful!

 

bump for a little help