Have a 95 civic auto which I am in the process of converting to manual. Has a B16 motor already swapped and had an auto tranny. Just put the ls tranny in and the conversion top tranny mount I bought from innovative is off by about 1/4-1/2" to the inside. I can barely see the hole in the bushing. Currently the only other mount attached is the driver side engine mount. I am wondering if:

A) I should not have unbolted the rear mount from the engine though I don't see how I would have gotten the trans out

B) The motor can be pushed over further with a pry bar and where a good spot to pry from would be?

Thanks so much.

 

Never mind. Prying worked. Now just have to get the rear mount lined up.