i have a 98 ctr swap im trying to put into a 2000 ex civic....long story short i have 98 harness on motor which has 3 plugs that go into ecu but still have 1 extra 32 pin plug that stayed in the car when single cam was pulled out......because i have that extra 32 pin plug with no where to go i have no feul pressure but car will try to start....im guessing problem is waith the fact that its obd2a ctr harness going into a obd2b car...HOW DO I FIX THIS???? looked at jumper harnesses on rywire.com but wanna make sure of a fix before i waste any more $$$...any help would be appreciated...thanks