I have a H22A in my civic, and I'm looking for the valve lash specs.

I stick the feeler guage in between the cam lobe and the rocker arm, correct? (first time doing this, can't be too hard, right?)

Just set the opposite cylinder to TDC, check the gap, re-gap (if nessicairy), and then lock it all up (then check again after it's locked).

 

not on an H22 but shows you step by step. I followed this a couple weeks ago, pretty simple, just time consuming. make sure to re-check the gap after tightening down the lock nut. after doing all cylinders I rechecked everything again and needed to make a couple more tiny adjustments.

http://www.c-speedracing.com/h...t.php

if the motor is still in your ride, prepare for a sore back. good luck!

 

i found the guide on here. got the exhaust valves done tonight.