Just looking for opinions.... Stock D16a6 w/216,000 mi.

I just got a price for them $100 each. So with that many miles do you think they are not working properly.

The car runs good but just off a bit. I have done...
Plugs and wires cap and rotor. timing too.
Ran seafoam through IM
Ran Lucas injector cleaner 2 times in the last few months.
Checked o2 readings and such. Fuel press and all.

Should I pull them, investigate, clean them and repl the seals?
Or should I just fork over the dough and know it is done with?

What would you do? Any other things to check?

Thx for reading...

 

I would say if you don't have any severe misfirings, just pull and inspect. If you notice a lot of gunk that lucas didn't clean you then replace them, but if they're clean, save the dough and just replace the o-rings.

 

Thanks Bart,

Yea I guess an inspection is in order. Off to get some seals.