Hey guys need a little help here, I got done installing a B16A2 into my EK hatch and it is doing great except for a bad engine shake. It is most noticable pulling hard through third and fourth gear, and is worst going through the 40-50 mph area. I have checked and double checked the motor mounts and they seem fine so now I am stumped.

Possible ideas that I had:

#1- Axles- not sure if this can cause a shake but the passenger axle was really hard to install?
#2- little torque mount for AC- the rubber is a bit torn but it was the same on the EG I got the motor out of and it had no shake?

Any help is greatly appreciated, I need to get this taken care of it feels like the motor is gonna rip out of the car

 

Wheel lugnuts.
Wheel balancing
Axles tweaked.

Check all of above.

 

Lug nuts- torqued to spec

Wheels - rebalanced recently (thought that could be the prob also)

Axles tweaked- Not sure how to check? Just look at them or is there a way to test them?

Thanks for the suggestions

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Spade &raquo;</TD></TR><TR><TD CLASS="quote">Wheel lugnuts.
Wheel balancing
Axles tweaked.

Check all of above.</TD></TR></TABLE>

all are fine.


https://honda-tech.com/zerothread?id=603464

I already made a post last night Jon

this is so stupid

 

A little more info here maybe it will help :

Everything worked perfectly in the EG that the motor was pulled from.

All the mounts are nice and tight.

I just removed bnoth axles and reinstalled them.

Still has the same shake! I am willing to try anything just need some more suggestions please.......