I have a dual stage boost controller and it comes with a switch that when you press it switches between high and low boost modes. The problem is that the switch that they provide me with is tacky and very suspect. And I do not want to buy another one. So I decided to use my cruise control button to serve that purpose, because I disconnected my cruise control…Here are the schematics.

The switch they provided me with has 3 connections. One is for ground, one is for power, and the next one says load. The Cruise control button has 5. A red-blk one that goes to a fuse under the dash, Red goes to dashlit brightness controller, and another one that goes to another fuse. These two go to a bulb I believe because it says “ILLUM”…There is a Blk-Yel that goes a fuse under the dash and is wired to the Off position. There is a Light green which goes to Power Input. And there is a back that goes to ground.


Crusie control schematics


Illum red- blk fuse
Red – dashlit controller
Blk-yel - Fuse


Off

On Lt Grn- Power input


On Indi Blk- Ground


Ground

Load—Goes to Boost controller

Power



Modified by 001020 at 10:52 PM 5/22/2005