Ecu Extension Harness
I was just wondering whats the best way to get a female end plug for a obd1 ecu so i can create a extension harness...somewhat like a conversion harness... the only way i can think of is to take my old ecu and rip out the female plug and connect my male end wires to the corresponding pins then maybe a solder and heat shrink to make it safer...any ideas or things that i should consider...thanks
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by locash »</TD></TR><TR><TD CLASS="quote">Check email, I have one of these obd1 ecu plugs brand new sitting here..</TD></TR></TABLE>
Email... I just need to know how people get the female side of the harness...i already have a male side i pulled from the junkyard...
Email... I just need to know how people get the female side of the harness...i already have a male side i pulled from the junkyard...
Thread
Thread Starter
Forum
Replies
Last Post




