Clutchmaster Cylinder
#1
Junior Member
Thread Starter
Join Date: Dec 2004
Location: Nati, Oh, U.S.
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Clutchmaster Cylinder
Hey guys, I have a 1995 Acura Integra over the past week or so I have noticed lower and lower clutch pedal engagment. Yesterday after work on my attempted drive home the clutch wouldn't engage at all. Upon checking the clutch fluid resivor I found it empty. I added more fluid pumped the clutch a few times to no avail the clutch still wouldn't engage. I couldn't find any leaks until I looked up underneath the dash by the pedal assembly. There was a small amount of fluid dripping near the rod which pushes into the piston. My first guess was a new clutchmaster cylinder was needed. I still haven't gotten the car home. I'm actually heading out to get it now. I"m wondering if anyone has any input on this before I start tearing into the situation.
Thanks in advance,
Josh
Thanks in advance,
Josh
#2
Re: Clutchmaster Cylinder (DoyouVtec)
yea you should definently change it just go get a new cmc from the dealer or if you want to save money go to the junkyards or local autoparts places a pick one up remember after you install your new cmc to bleed it
Thread
Thread Starter
Forum
Replies
Last Post
NFrank89
Transmission & Drivetrain
4
11-30-2009 07:27 PM
Fullthrottlegsr
Acura Integra
5
06-22-2005 01:21 PM