b18 block b16 rods ?ever done ?
Thread Starter
Joined: Feb 2006
Posts: 1
Likes: 0
From: irvington, al, usa
b18 block b16 rods ?ever done ?
i was wondering if anyone ever built this motor
b18b block
b18a crank
b16a1 rods
nippon racing pistons 12 5 1
with a b16a2 head
ferra valves
type valtrain springs retainers cams
well i did it. it took lots of machine work bottom end wise piston to crank clearance but and i assembled it with a few trips to acura for bearings . the motor turns smoth. the deck clearance is lower than i ever seen but not crazy low
i was thinking it might be a good boost motor i am still in the block to head stages now just got the head back yesterday .
b18b block
b18a crank
b16a1 rods
nippon racing pistons 12 5 1
with a b16a2 head
ferra valves
type valtrain springs retainers cams
well i did it. it took lots of machine work bottom end wise piston to crank clearance but and i assembled it with a few trips to acura for bearings . the motor turns smoth. the deck clearance is lower than i ever seen but not crazy low
i was thinking it might be a good boost motor i am still in the block to head stages now just got the head back yesterday .
Honda-Tech Member
Joined: Jul 2003
Posts: 2,271
Likes: 0
From: albany, ny, usa
Re: b18 block b16 rods ?ever done ? (joshyeame)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by joshyeame »</TD></TR><TR><TD CLASS="quote">i was wondering if anyone ever built this motor
b18b block
b18a crank
b16a1 rods
nippon racing pistons 12 5 1
with a b16a2 head
ferra valves
type valtrain springs retainers cams
well i did it. it took lots of machine work bottom end wise piston to crank clearance but and i assembled it with a few trips to acura for bearings . the motor turns smoth. the deck clearance is lower than i ever seen but not crazy low
i was thinking it might be a good boost motor i am still in the block to head stages now just got the head back yesterday . </TD></TR></TABLE>
Retard of the year award goes to......
b18b block
b18a crank
b16a1 rods
nippon racing pistons 12 5 1
with a b16a2 head
ferra valves
type valtrain springs retainers cams
well i did it. it took lots of machine work bottom end wise piston to crank clearance but and i assembled it with a few trips to acura for bearings . the motor turns smoth. the deck clearance is lower than i ever seen but not crazy low
i was thinking it might be a good boost motor i am still in the block to head stages now just got the head back yesterday . </TD></TR></TABLE>
Retard of the year award goes to......
Thread
Thread Starter
Forum
Replies
Last Post
weiRtech
All Motor / Naturally Aspirated
5
Aug 24, 2006 11:00 AM
