If i wanted to take the rotational assembly from my B16b and put it into a B18c block it would work correct? I was looking at the Dart block with the 84mm bore...besides larger pistons what else would i need to make this work? I dont want to stroke it simply because i want to keep its rod stroke ratio

 

b16b rods won't fit(too short) cuz b18c deck is taller

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by d16vtecx &raquo;</TD></TR><TR><TD CLASS="quote">b16b rods won't fit(too short) cuz b18c deck is taller</TD></TR></TABLE>

The B16A has a shorter block. The B16B (EK9 Civic Type R) shares the same block with the B18C series. Yes, it will work just fine.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Dogginator &raquo;</TD></TR><TR><TD CLASS="quote">

The B16A has a shorter block. The B16B (EK9 Civic Type R) shares the same block with the B18C series. Yes, it will work just fine.</TD></TR></TABLE>





&gt;&gt;&gt;&lt;&lt;&lt;