i have skunk2 cam gears on my stock b16a stock cams too. uhm i was wondering should i advance both cams the same or how would you otehrs suggest to adjust the cam gears

 

You must dyno tune to get the best results, but try this:
Intake advanced 2 degrees
Exhaust retarded 1 degree.
That gives gains on most B16s I've seen. Depending on mods sometimes 3 for intake.

 

well i have header exahust and intake. so when u advance that means spin towards the front of the car rigth? i am just pretty much ******* around while my damn b20 block gets back cause i want to hear wut my greddy PE sounds like with a 4-1 dc header and 2 1/2 from the header back with no cat haha

 

I don't know about Skunks, but my AEM cam gears have an "A" and an "R" on them. Move the little hash mark towards the "A" to advance and towards the "R" to retard.