trying to work out wiring problems with this swap, can i modify the dash to accept an integra gauge cluster (the two are very different sizes and shapes), or is there some other perferred method? I really dont want to have to rewire the entire car, but would like to run OBD1 in the car.
Thanks

 

evening crowd, someone must know

 

You don't need to completely rewire your car. Actually, the conversion is quite simple. You just need to change your ECU plugs to 1992-1995 plugs and change a few plugs under the hood. Take a look at my wiring guides for DX swaps on the hybrid board of resource.crx.org. Also, you don't need to change the gauge cluster. The in-dash VSS on 1988-1991 cars works fine with a 1992+ ECU.

 

dx have mpfi and std has single point though so all the in engine bay wiring has to change doesnt it?