I have a 24mm rear swaybar from asr and the asr subframe brace, I also have skunk2 rear lower control arms. I used the endlinks that came with the rear sway bar kit from ASR, and they are shot they make so much noise its ridiculous, I was wondering if I can use OEM endlinks with that setup, I am not sure if it would work with the lower control arms. This is all on a 2000 ek coupe

 

So does anybody know if the oem endlinks work on skunk2 lower control arms???

 

I hope you know your endlinks are not shot, spherical endlinks are known to click. Stock styled endlinks should work though

 

I know, but they are seized horribly bad, I am just going to go with OEM ones.

 

Oem should work just fine.

I have sphecials in mine front and rear, and just a slight clunking when one wheel hits a bump and other doesnt at low speeds.
It's just something youll have to deal with if you go with them.

 

I had the same thing happen to my asr links. They had a few mm of play. I replaced them with the new Whiteline end links. So far it's quiet. 60mm with 10mm studs it what I got.
http://www.whiteline.com.au/docs/bul...ar%20links.pdf