What size is this fitting? (water in/out on a wet T3 CHRA)
Thread Starter
Honda-Tech Member
Joined: Nov 2001
Posts: 3,492
Likes: 0
From: San Jose, CA, USA
What size is this fitting? (water in/out on a wet T3 CHRA)
As the title says, what size is this?
The OD on the threads is about .685"
I want to run some AN fittings instead of the hosebarbs for my water fittings, and I need to know what size to get. I was thinking some -6 hose with some socketless hose ends, but I don't know what size adapter I need. It's definitely smaller than the 1/2 NPT that's used for the drain flange, so I'm guessing it's 3/8 or 1/4 NPT?
Any help is greatly appreciated.
The OD on the threads is about .685"
I want to run some AN fittings instead of the hosebarbs for my water fittings, and I need to know what size to get. I was thinking some -6 hose with some socketless hose ends, but I don't know what size adapter I need. It's definitely smaller than the 1/2 NPT that's used for the drain flange, so I'm guessing it's 3/8 or 1/4 NPT?
Any help is greatly appreciated.
Thread Starter
Honda-Tech Member
Joined: Nov 2001
Posts: 3,492
Likes: 0
From: San Jose, CA, USA
Re: What size is this fitting? (stealthmode62)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by stealthmode62 »</TD></TR><TR><TD CLASS="quote">My Garrett T3 used 3/8 threads. Looks the same to me. 
</TD></TR></TABLE>
thanks, I was thinking it was 3/8, just wanted to confirm
</TD></TR></TABLE>thanks, I was thinking it was 3/8, just wanted to confirm
Thread
Thread Starter
Forum
Replies
Last Post
the.hamburglar
Forced Induction
12
Mar 4, 2006 09:34 AM
inspyral
Forced Induction
3
Sep 8, 2004 08:17 PM
