What size is this fitting? (water in/out on a wet T3 CHRA)
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2001
Location: San Jose, CA, USA
Posts: 3,492
Likes: 0
Received 0 Likes
on
0 Posts
What size is this fitting? (water in/out on a wet T3 CHRA)
As the title says, what size is this?
The OD on the threads is about .685"
I want to run some AN fittings instead of the hosebarbs for my water fittings, and I need to know what size to get. I was thinking some -6 hose with some socketless hose ends, but I don't know what size adapter I need. It's definitely smaller than the 1/2 NPT that's used for the drain flange, so I'm guessing it's 3/8 or 1/4 NPT?
Any help is greatly appreciated.
The OD on the threads is about .685"
I want to run some AN fittings instead of the hosebarbs for my water fittings, and I need to know what size to get. I was thinking some -6 hose with some socketless hose ends, but I don't know what size adapter I need. It's definitely smaller than the 1/2 NPT that's used for the drain flange, so I'm guessing it's 3/8 or 1/4 NPT?
Any help is greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
KeithDigital
All Motor / Naturally Aspirated
2
11-23-2008 06:02 PM
inspyral
Tech / Misc
3
09-08-2004 08:59 PM