With B16B Pistons in a Sir B16 should I just machine the connecting rods or pistons or purchase B16B connecting rods.

 

should fit on with no problems if my memory serves me right

 

umm.. CTR pistons will not fit on the b16 rods.. you gotta machine either the rod or piston. as for buying CTR rods.. it would be a tad bit too long.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by B20Monster &raquo;</TD></TR><TR><TD CLASS="quote">as for buying CTR rods.. it would be a tad bit too long. </TD></TR></TABLE>
Would the conrods be too long to where they wouldn't clear the bottom end or, would the piston go into my Head

 

into head

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by B20Monster &raquo;</TD></TR><TR><TD CLASS="quote">as for buying CTR rods.. it would be a tad bit too long. </TD></TR></TABLE>

I thought that they were the exact same as the B16 rods except for the piston end.

 

B16B is a taller block than a B16A. The rods on the B16B are taller than on B16a. The two blocks are nothing alike.