yeah i am having some problems figuring out which pin on the sensor goes where. i am posting a pic of the sensor. i know its blurry but its the best i could do. if someone could tell me from left to right on the sensor where each pin goes.

thanks

 

by the way its a h22 swap done on a 92 cx

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by poison &raquo;</TD></TR><TR><TD CLASS="quote">EGR (Exhaust Gas Recirculation) System: Applies to all model civics except VX using the VX engine harness. If you do not use the VX engine harness in a VX, then you need to do this!

- EGR lift valve solenoid - sensor voltage (A25 pinout) & ECU signal to A11
- EGR lift sensor - sensor voltage (A25 pinout), ground (D22 pinout) & ECU sensor signal to D12
</TD></TR></TABLE>

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by turbogixxer &raquo;</TD></TR><TR><TD CLASS="quote">EGR Wiring Info

USDM wire colors are the same as JDM.

Connector colors means that when looking at the connector (wire pointing towards you) that the way they should line up (From left to right)

EGR lift valve solenoid
(The connector colors, From left to right) BLK/YEL and RED

Sensor Voltage - BLK/YEL - goes to A25
ECU trigger - RED - goes to A11.

EGR Lift Sensor (the actual EGR on the intake manifold)
(The connector colors, From left to right) WHT/BLK, GRN/WHT, and RED/WHT

ECU trigger - WHT/BLK - goes to D12
Sensor ground - GRN/WHT - goes to D22
Sensor voltage - RED/WHT - goes to D19 or A25
</TD></TR></TABLE>

 

Looking at the sensor....

WHT/BLK - to D12............Left
GRN/WHT - to D22..........Middle
RED/WHT - to D19 or A25........Right