well today my starter grenaded.....so i figured...pop the clutch, go to the shop and get a new starter....welll them i see oil on the ground....my tranny has a ******* hole because a ******* socket was stuck between the axle and the tranny....now i have to get a new starter and a new tranny man i am fucked...did i mention this is on my JDM(JUNKYARD DOMESTIC MARKET) B16 swap???

 

who did the nice work on the car? if it was you that car has no future.

 

umm yeah, my car has a future, i had just sat the sockets up on the engine, while i was removing the starter.....then i popped the clutch to start it later, while it was warming up, i noticed a socket on gone so i went out and looked......it was on the ground in oil.......so umm trip to the machine shop on the morning...the hole is in a easily accessable place......just taje out the axle....but i am sure there is more damage..will know in the morning....man that i got fucked on this motor...let me tell you..the ECU was cracked....no midshaft.....but for 1000 what can you expect...let me stop ranting about it...

 

thats rough bro. i hope theres no serious damage. get that **** fixed and back on the road ASAP.

good luck

 

yeah i drove it around the block...and it runs fine...just gotta get that hole patched...

 

Good luck with that hole.

 

OUch sorry to here that good luck bro!

 

If I were you, Id invest in a magnet tray.

sorry to hear bout your bad luck.

 

yeah i know...i am seriously thinking about it...........as for the hole....it is sooooo small...just all the oil had me scared....i can barely get my finger in the hole......JB weld to the rescue