i have a flowmaster 2.25 in/out and im going to get it installed..most likely at this point, just have it welded to my stock catback, no new piping at this moment. but im wondering what u guys think an average price for this job should be, just to cut and reweld basically...thanx

 

If it is just the mufller then i would say $25 or so... but im not sure it depends where you take it to.

 

id say 25 bucks aswell

 

alright, thats what i was thikning..i went to this one place, and this guys like well..i dont know for sure, but 80 give or take..and im like, yea sure buddy..right on that

 

well i figure it would be a waste to just put on a muffler and still use your stock catback, i had a thermal axleback and asked for 2.25" piping (cat to axleback) and it was 100$

 

Yea i got a cp racing muffler and got catback 2.5" piping for 130

 

around 100 bucks if youre gonna get piping cut, if theyre just welding the muffler to existing piping then i would say between 20 and 30 bucks